Finished up with the CM.  Training and the cal/test procedures went very well, albeit lots of work!  Also worked on some updates to the cal trimming to accommodate wider part variations.  So we're all good...

OK!  Tomorrow is my flight back to the USA to oversee and train for the new batch of Natural Gates with our new manufacturer!  So long as there are no setbacks, we should be shipping...

We were able to clear a quick video at our CM of a panel of NGs going through SMD.

Hello folks!

I have some dates from the CM and I'm booking flights to oversee production (which has already started).  SMT has already begun and likely completed by the time this is posted.

Calibration and...

Hello!

The drum module is about 90% the way there. The prototype many tried at Superbooth will get several changes.  It is only till recently that we have put the CV inputs through the ringer and we...