We ran into a little hiccup at our CM - they wore down the jack nut installation tools I supplied!  The tips of these were brass so I quickly had some new ones CNC'd out...

Heyo! 

In assembly and QC as a few nearly-finished units come on down the line!

As always thanks for patience - they will be shipping soon!

Finished up with the CM.  Training and the cal/test procedures went very well, albeit lots of work!  Also worked on some updates to the cal trimming to accommodate wider part variations.  So we're all good...

OK!  Tomorrow is my flight back to the USA to oversee and train for the new batch of Natural Gates with our new manufacturer!  So long as there are no setbacks, we should be shipping...

We were able to clear a quick video at our CM of a panel of NGs going through SMD.