Hey folks!  We were hoping to get these out today but look like we'll need another couple days (hoping to have stuff shipping before end of week!)

Today I got all of the pre-order address...

We ran into a little hiccup at our CM - they wore down the jack nut installation tools I supplied!  The tips of these were brass so I quickly had some new ones CNC'd out...

Heyo! 

In assembly and QC as a few nearly-finished units come on down the line!

As always thanks for patience - they will be shipping soon!

I've been daydreaming a lot about the kick module... I was not entirely happy with it - not in terms of sound or nuances in how we create this sound, but its role in a...

Finished up with the CM.  Training and the cal/test procedures went very well, albeit lots of work!  Also worked on some updates to the cal trimming to accommodate wider part variations.  So we're all good...